How to Replace a Ceiling Fan With a Light Fixture

Neighborhood QA

Add New Question Ask a Query 200 characters left Embody your electronic mail tackle to get a message when this query is answered. Submit



Optimum Sizing, Pace, and Placement

Use this formulation to seek out the very best fan dimension for a room’s occupied area (the a part of the room the place individuals collect probably the most): Occupied area (in sq. ft) divided by 4 equals the blade span (in inches). Step blade span down a bit for rooms with low ceilings, and go wider if the ceilings are excessive.

One other good rule of thumb is to do not forget that blade spans of lower than 36 inches are perfect for areas smaller than 75 sq. ft, resembling baths and breakfast nooks. Spans of 36 to 42 inches work in rooms of as much as 225 sq. ft, like a eating room. Bigger residing rooms and bedrooms can deal with 50- to 54-inch blades.

Be sure that the cubic ft of air that the fan strikes per minute (cfm), measured at excessive pace, is close to the highest of its class. Some 52-inch followers, as an illustration, charge as little as 2,050 cfm, whereas others attain 7,800. Excessive-cfm followers not solely present a greater breeze, they often have strong motors that can last more and run extra quietly.

For optimum efficiency, the fan needs to be hung no less than 1 1/2 ft from the wall or a sloped ceiling, 7- to 10-feet from the ground, and no less than 8 inches from the ceiling. Avoid hanging the fan too near any lights, as rotating blades below a bulb will create an annoying flicker.


Pull the wires out of {the electrical} field and unscrew the wire nuts, then pull aside the wires. Decrease the ceiling fan. This will require the assistance of an assistant to carry the fan when you disconnect wires. Take away the mounting bracket, generally referred to as a strap, that spans {the electrical} field.


Carry the sunshine fixture’s base into place. Most mild bases have curved, slotted holes into which the mounting screws match. Tighten the mounting screws till the bottom is tight towards the wall. Don’t overtighten. The bottom shouldn’t be free or be capable of be turned simply by hand.

Join the Publication

Get the most recent This Previous Home information, trusted suggestions, tips, and DIY Smarts initiatives from our specialists–straight to your inbox.


Leave a Comment